Practical Guide to Carbon Monoxide Detector Maintenance

By | November 25, 2017

carbon monoxide detector maintenance
Many home owners take carbon monoxide detector maintenance quite lightly. Some individuals will only do so when there is a fault. Others will delay carrying out the maintenance. Usually, this can lead to disasters.

Carbon monoxide poisoning or even untimely death may occur. Going by statistics from Consumer Products Safety Commission (CPSC), approximately 8,000 individuals are injured and 200 are killed by carbon monoxide annually. To avoid being part of the statistics it is important to follow the maintenance guidelines below:

Clean the Unit Regularly

The carbon monoxide (CO) detector is prone to dirt, dust and other debris. This may infiltrate the system thus affecting its sensitivity. The unit may fail to detect low volumes of the odorless and colorless gas.

Small volumes are also as dangerous as high volumes especially in the long run. The dust, dirt, cobwebs and other foreign elements can be removed by gently vacuuming the unit. It is important to use low pressure since too much may dislodge some components making it less sensitive.

Battery Replacement

CO detectors are generally plugged into or connected to the electrical system. But, they also have a backup battery which offers power in case of outages.

Like any other battery, it will wear out over time. Too much heat or cold may shorten its lifespan. It will deliver insufficient energy which may affect the effectiveness of the detector. It is advisable to replace the battery once in a year.

The replacement battery should be similar to the battery that is being removed or should be recommended by the manufacturer.

CO Detector Sensor Component Replacement

The most important part of a CO detector is the sensor component. This device is what senses the presence of any carbon monoxide.

A good sensor should trigger the alarm immediately it detects any CO however minimal it may be. However, it becomes less reliable over time.

This may be attributed to the normal wear & tear, mishandling, or accident. It is recommended to replace the co detector sensor component once in every two years.

Maintaining the carbon monoxide detector is relatively easy and straightforward. Any person with basic skills can be able to clean the unit, replace the batteries, and also change the sensors.

All what is needed is time, a bit of effort, and patience. But, it is important to only use quality and genuine parts. The batteries should be durable and the sensors should be approved and recommended by the manufacturer.

By following the above guideline on carbon monoxide detector maintenance chances of carbon monoxide poisoning are minimal.